http://www.wranglerforum.com/ en Fri, 20 Nov 2009 22:09:43 GMT vBulletin 60 http://www.wranglerforum.com/images/misc/rss.jpg http://www.wranglerforum.com/ http://www.wranglerforum.com/f8/interior-lights-40143-new-post.html Fri, 20 Nov 2009 20:33:37 GMT I have a 94 2.5L 5 speed. Neither of the courtesy lights work, despite the bulbs being good, and I also have the sound bar from a 95 with the light in it, that also has a good bulb, and is hooked up, but doesn't work. Anyone know just which fuse it is to check, or have any other ideas? ]]> YJ Jeep Wrangler Forum Pylonpounder http://www.wranglerforum.com/f8/interior-lights-40143.html http://www.wranglerforum.com/f8/clutch-problem-40142-new-post.html Fri, 20 Nov 2009 20:28:13 GMT I was driving yesterday, drove a total of around 70 miles. Everything was fine up until I was about 3 minutes from home, when my clutch just stopped working. Straight to the floor, wouldn't disengage the gears. Could put it to the floor and still accelerate. Tried pumping it, didn't work. I got home by matching revs to shift instead of clutch, and never actually stopping. Got home, turned off the vehicle, went through the gears without clutch, then with clutch, which felt back to normal when off. Turned it on- and it worked. Reversed, 1st gear, anything I wanted. Drove it again today, no problems. I'm just curious what caused it...and if it's going to be a recurring problem I need to look into. It was raining, if that helps anything. I replaced the starter awhile ago with a bosch OEM replacement, which was for some reason slightly smaller than the original- It left a gap under it leading into the clutch housing. However, I sealed that with hi-temp liquid gasket. I asked a friend who is on their third jeep (a 2000 TJ) and has never owned an auto in their life, and they haven't a clue either. Posted on JP while this site was down last night...no response there, though 50 views. Anyone got any ideas? Thanks for your help in advance.

Edit: Also, I have to say that my clutch master cylinder DOES leak, but very slowly. Checked the fluid today, still at the same level that I topped it off to three weeks ago.

Edit again: Oh yeah. It's a 94 2.5L 5 speed. ]]> YJ Jeep Wrangler Forum Pylonpounder http://www.wranglerforum.com/f8/clutch-problem-40142.html http://www.wranglerforum.com/f8/help-needed-no-spark-no-fuel-40132-new-post.html Fri, 20 Nov 2009 17:08:55 GMT Hello all, I have a 1989 Wrangler YJ 2.5 TBI. It was running great and then it just shut down. Now I have no spark out of the coil and no fuel pump. If I run a wire to the pump from the batt the pump runs fine. We have changed the brain,coil,crank trigger but still nothing. On another board someone... Hello all, I have a 1989 Wrangler YJ 2.5 TBI. It was running great and then it just shut down. Now I have no spark out of the coil and no fuel pump. If I run a wire to the pump from the batt the pump runs fine. We have changed the brain,coil,crank trigger but still nothing. On another board someone said to check the ASD relay I have no idea where it is to check or what it looks like. I have two black relays next to the batt and one bolted to the fire wall it is an oblong steel one with a mounting tab spot weled to it. I have power going to the brain/coil but nothing out of the coil. I need help. Thank you All. Steve in Cocoa ]]> YJ Jeep Wrangler Forum PilotMan http://www.wranglerforum.com/f8/help-needed-no-spark-no-fuel-40132.html http://www.wranglerforum.com/f8/need-help-40128-new-post.html Fri, 20 Nov 2009 16:11:26 GMT ok so ive been having problems with my 89 2.5... ive changed the distributor cap rotor wires plugs coil ignition module ecm fuel pump and every relay and fuse i can find, ive also looked through the wiring but i still have a problem. ive noticed it runs alot better with the new parts but when i... ok so ive been having problems with my 89 2.5... ive changed the distributor cap rotor wires plugs coil ignition module ecm fuel pump and every relay and fuse i can find, ive also looked through the wiring but i still have a problem. ive noticed it runs alot better with the new parts but when i take a left turn it boggs and sometimes stalls... i have no clue what is making it do this. has this happened to any one before or does anyone know what would be causeing this to happen. please help its my daily driver and i need it back on the road asap. thank you


Tom ]]> YJ Jeep Wrangler Forum The89YJ http://www.wranglerforum.com/f8/need-help-40128.html http://www.wranglerforum.com/f8/gas-mileage-40113-new-post.html Thu, 19 Nov 2009 18:25:25 GMT has anyone improved gas mileage for the 4.0, its auto, by adding a aftermarket part to engine, a couple of MPG would be fine. has anyone improved gas mileage for the 4.0, its auto, by adding
a aftermarket part to engine, a couple of MPG would be fine. ]]> YJ Jeep Wrangler Forum bayman http://www.wranglerforum.com/f8/gas-mileage-40113.html http://www.wranglerforum.com/f8/anyone-have-experience-with-bestop-seats-risers-40095-new-post.html Thu, 19 Nov 2009 09:33:16 GMT Changing out my drivers seat, to a Bestop trailmax (trailmax II I think). Got the Bestop riser to go with it. The instructions say to reuse my old seat track slide, but it's torn up and unusable.

Here's the n00b question: Do I even need a seat track slide with this seat and riser? I can't figure out what the track slide does, and my passenger seat (which as far as I know is original) doesn't even seem to have one. Also Bestop doesn't seem to make seat track slides, haha.

So can I mount the seat directly to the riser?

Many thanks for any advice. ]]> YJ Jeep Wrangler Forum KTC http://www.wranglerforum.com/f8/anyone-have-experience-with-bestop-seats-risers-40095.html http://www.wranglerforum.com/f8/soa-caster-angles-help-questions-40087-new-post.html Thu, 19 Nov 2009 04:13:10 GMT I am begining to start the soa part of my project and I have a few ?'s. What is the recommended caster angle to use, the factory? Or should I do whats best for the front driveshaft angles? And for the back? I want to mainly set it up for the best driveshaft angle for vibes in the back. I also have a 1"bl with stock springs would I be able to run 35"s and flex all the way out and have full turning? I plan on making the fenders flatties. Any input would b great. ]]> YJ Jeep Wrangler Forum Jman062006 http://www.wranglerforum.com/f8/soa-caster-angles-help-questions-40087.html http://www.wranglerforum.com/f8/small-block-tj-40085-new-post.html Thu, 19 Nov 2009 04:02:53 GMT I have just bought a 95 TJ with a 351 and 4sp. The front end does lock in if I run a vacume line to the front diff. actuator so I know it works. My question is what is available aftermarket with a switch to do this automatically. This is usually done by the factory transfercase but not its been... I have just bought a 95 TJ with a 351 and 4sp. The front end does lock in if I run a vacume line to the front diff. actuator so I know it works. My question is what is available aftermarket with a switch to do this automatically. This is usually done by the factory transfercase but not its been replaced by a 4sp. Any suggestions will help me!! Thanks, Art ]]> YJ Jeep Wrangler Forum 4x4_fun http://www.wranglerforum.com/f8/small-block-tj-40085.html http://www.wranglerforum.com/f8/fuel-filler-tube-40073-new-post.html Thu, 19 Nov 2009 00:18:55 GMT Ours was rotted to the point that at 1/2 a tank it'd start leaking when filling up. Called around to a few parts stores, even quadratec...no one has one for a 14 gal tank. So I called the dealer only to find out they are discontinued?!?! How can a part like that be discontinued? Guess I am the only person left with a 14 gal gas tank...lol Anyway what do you guys think a good replacement for this hose would be? ]]> YJ Jeep Wrangler Forum 19yj89 http://www.wranglerforum.com/f8/fuel-filler-tube-40073.html http://www.wranglerforum.com/f8/new-shock-suggestions-please-40071-new-post.html Wed, 18 Nov 2009 23:18:57 GMT Gonna put on a new set of shocks in the next couple weeks. Any ideas on type, brand etc would be appreciated. Stock suspension Beach Driver Little to none off road, occasional dirt paths etc 50,000 miles Thanks guys Gonna put on a new set of shocks in the next couple weeks. Any ideas on type, brand etc would be appreciated.

Stock suspension
Beach Driver
Little to none off road, occasional dirt paths etc
50,000 miles

Thanks guys ]]> YJ Jeep Wrangler Forum copleydad http://www.wranglerforum.com/f8/new-shock-suggestions-please-40071.html http://www.wranglerforum.com/f8/power-steering-brackets-40069-new-post.html Wed, 18 Nov 2009 22:38:26 GMT i have the pump and steering box for the 2.5 but i am looking for the brackets to mount the pump to the engine since someone already took them off. Thanks Matt i have the pump and steering box for the 2.5 but i am looking for the brackets to mount the pump to the engine since someone already took them off.

Thanks

Matt ]]> YJ Jeep Wrangler Forum cwbymt1973 http://www.wranglerforum.com/f8/power-steering-brackets-40069.html http://www.wranglerforum.com/f8/getting-steamy-inside-40058-new-post.html Wed, 18 Nov 2009 18:09:01 GMT Hoo boy, I must have done something to get my little 89 wrangler excited because it decided to start getting steamy inside when I drive it now,, There is vapor coming out from under my dash, even fogged up the inside of the gauges and my stereo. It`s my heater core isn`t it? Hoo boy, I must have done something to get my little 89 wrangler excited because it decided to start getting steamy inside when I drive it now,,
There is vapor coming out from under my dash, even fogged up the inside of the gauges and my stereo.
It`s my heater core isn`t it? ]]> YJ Jeep Wrangler Forum Rainycity http://www.wranglerforum.com/f8/getting-steamy-inside-40058.html http://www.wranglerforum.com/f8/wont-start-40054-new-post.html Wed, 18 Nov 2009 16:23:36 GMT I changed out the ignition switch in my 88 wrangler. Put everything back together, but not it work start. All the power turns on, but doesnt even attempt to start? Anyone have any suggestions as to what i need to do? I could really use a hand, or someone to come do this for me.... I changed out the ignition switch in my 88 wrangler. Put everything back together, but not it work start. All the power turns on, but doesnt even attempt to start? Anyone have any suggestions as to what i need to do? I could really use a hand, or someone to come do this for me.... ]]> YJ Jeep Wrangler Forum 88wranglerLa http://www.wranglerforum.com/f8/wont-start-40054.html http://www.wranglerforum.com/f8/intake-fittings-40044-new-post.html Wed, 18 Nov 2009 13:40:32 GMT I have a 4.2 in my YJ, and I have sprung a leak on one of the intake cooling fittings. It is the elbow where the coolant hose connects to the intake manifold, there is one on each end of the manifold. The stealership wants 30$ each for those elbows and it will take a week to get them from the... I have a 4.2 in my YJ, and I have sprung a leak on one of the intake cooling fittings. It is the elbow where the coolant hose connects to the intake manifold, there is one on each end of the manifold. The stealership wants 30$ each for those elbows and it will take a week to get them from the "vintage" department. Has anyone tried replacing them with like a brass nipple of something? The factory ones seem to rust out quite easily. Thanks ]]> YJ Jeep Wrangler Forum Streetdoc432 http://www.wranglerforum.com/f8/intake-fittings-40044.html http://www.wranglerforum.com/f8/exterior-lights-40038-new-post.html Wed, 18 Nov 2009 09:29:09 GMT I own a 1995 Jeep Wrangler. I know the previous owner and it is in great shape. The only problem I am having with it is the lights. I was driving the other day and my dash lights went out as did my tail lights. My brake lights are working, but nothing else in the back. My headlights are also... I own a 1995 Jeep Wrangler. I know the previous owner and it is in great shape. The only problem I am having with it is the lights. I was driving the other day and my dash lights went out as did my tail lights. My brake lights are working, but nothing else in the back. My headlights are also working but, in the past, they tend to stop out of nowhere even though the button to turn them on is pressed in. Anyone have any ideas as to what has caused my dash boad/guage lights and tail lights to go out simultaneously? Any feed back would be greatly appreciated. ]]> YJ Jeep Wrangler Forum thegoodfight07 http://www.wranglerforum.com/f8/exterior-lights-40038.html