Originally Posted by Pank-da-tank
Was wondering if anyone had to do any trimming away at the wheel wells to get the smittybilt rear XRC armor to fit properly. I heard from a guy who said he had to do some cutting and I was wondering how much if any it would take to get a good fit.
The Smittybilt XRC armor install is a very involved installation. They take a lot of time to get them to fit just right. I know a few guys who have installed them and said they were kind of complicated to install. As for trimming I don;t know if you will have to trim your Jeep or not. Here are the Installation Instruction
s right off of Smittybilt's site.
Hope this helps, shoot me a PM if you have any other questions!