For Sale: Very well built rock crawling sleeper Jeep. May be small, but mighty. Wheel w/ your buddies with bigger rigs!
1990 Jeep Wrangler, 2.5l 4 cyl., fresh low mileage motor swap w/ all new seals, gaskets and valve job on head. Elec. Fan, new water pump, hoses & t-stat. New PS pump w/ oil cooler. Yellow top Optima battery. New plugs, wires and fuel filter. New muffler w/ tail pipe. New cone air filter.
5 speed tranny w/ new clutch, pressure plate, slave cyl. and surfaced flywheel. Also installed Tri-county inertia ring on flywheel. (Helps w/ low end torque and helps maintain engine momentum.)
NP 231 t-case w/ tera low 4:1 kit, SYE kit and CV drive line.
Custom suspension w/ spring over conversion. All spring mounts and shackles, moved up into frame, won’t hang up on stuff. Long travel shocks.
Front axle, Dana 30, 4:10’s, w/ later model solid axle shafts milled to accept snap rings instead of c-clips on u joints, forged u joints, lockrite locker, HD steering made from 1.25”, .250 wall DOM tubing and ¾ ton tie rod ends, HD diff cover, braided SS brake lines.
Rear axle, 8.8 Ford explorer, 4:10’s, disc brakes, mini spool, HD diff cover. Shaved diff, gained 1.25” ground clearance!
Skid plates, bumpers and armor, body mount skid plates, 3/8” engine skid, 3/8” FLAT
belly tranny and t-case skid plate, rear drive line skid plate that doubles as an anti-wrap bar, ¼” skid plate on gas tank. 3/16" Poison Spyder crusher corners w/ custom steel flares, ¼” wall- tubing bumpers, rock slider protectors that wrap under to the frame w/ rock rails, body mount skids, 3/16" armor that rolls up the cowl, swing out tire and jack carrier, full roll cage w/ seats mounts tied into cage, flat front fenders w/ steel flares. Removeable tunnel to access tranny and t-case and drivelines.
Misc. New racing seats w/ lap belts, Warn 8274 winch w/ 100’ cable, Allied rock-a-thon 15” 32 bolt bead locks w/ air down petcocks in wheel, 32x11.50 Super Swamper TSL SX tires 40% tread-still really good tires.(You could run 35”s w/ no breakage problems), Full soft top w/ half doors.
I have wheeled this Jeep on hard trails for 3 years, it has never broken down or left me stranded. It has been from Moab to Hot Springs and Colorado. I built this myself and am ready to move onto a different project. Jeep has light scratches. I consistently wheel w/ rigs that have 35’s to 37’s and can keep up all day. If you want a serious rig this is it.
This is an itemized list of all the parts it would take to build this jeep.
Warn 8274 winch. $800.00 (new $1620.00), Yellow top deep cycle Optima battery $190.00, Seats $300.00, Elec. Fan $305.00, Cold air intake $200.00, Allied rock a thon beadlock wheels $875.00, SOA Lift kit w/ custom spring mounts-shackle reversal-SS brakelines-long travel shocks $500.00, H. D. Steering $210.00, Engine skid $260.00, Gas tank skid $270.00, Cross member & flat belly tranny skid $410.00, Driveline skid $200.00, H.D. Diff covers fr. $65.00 - rear $150.00, SYE $315.00, CV Driveline $390.00, HD Rear bumper w/ spare tire carrier $350.00, HD front bumper w/ anchor points $200.00, Rock sliders $290.00, Cowl armor $250.00, Full cage $560.00, Flat front fenders w/ steel flares $595.00, Rear crusher corners w/ steel flares $600.00, Removable windshield $75.00, Tera low 4:1 t-case kit $1120.00,
Front axle- lockrite $250.00, HD shafts w/ large joints $400.00.
Rear axle- 8.8 $250.00, Shaved housing $100.00, Mini spool $100.00.
Water pump, ps pump, ps cooler, bosch plugs, clutch and flywheel, valve job $525.00
Tri county gear inertia ring $190.00
TOTAL OF PARTS ALONE IS $11,295.00 That’s no shipping and no labor.
How much labor??? 100hr….. 200hr @ $30.00-$50.00????? You'll have to be the jugde of that!
KBB has the private party value for just the jeep @ $2000.00 that puts the total @ $13,295.00
I hope this helps.
Stan 479 790 7967 This jeep lives in Siloam Springs, AR
Some pics....clic to enlarge
All the black stuff on the body is the body armor.