Here is a one man bleed and it works. Open the top of the Master and make sure it is full and leave thhe cover off. Go underneath and remove the slave cyliner two bolts and hold slave in hand piston pointed at the floor. Grab the piston while it is pointed to the floor and actuate 20 times. Wait a minute check the level in the master and repeat. Install slave cyl;inder and check fluid level in master put the cap and it should be good.
Sounds like a bad story but that is how you bleed the new plastic slave with no bleed nipple. That iis right out of the instructions. So give it a try it really works.
89 2.5 TBI, 4" RC lift, 1" Booms, SYE, Adams Driveshafts front and rear, Ford 8.8 with 4:88s, BFG 33X12.50X15, and a ton of other stuff.
AF Jeep Club Tail Number 184