JKS motor mount and body lift - Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion

Join Wrangler Forum Today

Thread Tools

Please support our sponsors and let them know you heard about them on WranglerForum.com
Old 05-15-2013, 08:50 PM   #1
Join Date: Apr 2013
Posts: 15
JKS motor mount and body lift

I hard a difficult time installing a jks 1"motor mount today. The instructions said to use a jack on the transmission or transfer case. My main concern was the angle seemed to be needing to be jacked in the front of the motor- the front hole needed to be higher than the rear hole of the motor mount frame. It used a 4 foot pry bar and a hammer, but it's installed. I felt this was excessive, but I tried to be nice for hours.
I tried to install these before the body lift because I had limited time and wanted to get the daunting one first. I didn't get it, so I put the stock back in, then installed the 1 1/4" JKS body lift thinking that could change things. It didn't. Same problems later.
Also that AC was supposed to be in the way of the cross bolt. It wasn't even near it. 97tj 4.0.

It all seems good, but was wondering if anyone else ran into a bad angle problem like this.

97TJInSC is offline   Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Download our Mobile App

» Featured Product

All times are GMT -5. The time now is 06:49 PM.

User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2015 DragonByte Technologies Ltd.

Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC