Hi, I am new to the forum and going to be offering projector headlight to the community. I have a set up for sale right now on e-bay but I am going to be offering them cheaper becuase of being part of your community. I look foward to building you guyes headlight that will suit your need.
I am going to try and answer everyone questions in one post so bare with me. First I have 4 versions, Version 1 is a halogen set up with a h9 bulb gives much better beam coverage and just a better beam, version 2 is the same kit with hid bulb, version 3 is a better projector and better hid, version 4 is the best being a bi xenon high and low hid and a true hi/lo not a rebased bulb. These are plug and play units and are extremely easy to install. Version 1 is going to cost $450, Version 2 $950, version 3 $1150, version 4 $1700. They are very resonably priced as to what it took to engineer a new adjust assembely, they are laser cut. I will post pics of beam pattern as of right now I only have hid pics
These are as tough as they get. Doubled sealed. They will not leak unless your car goes under water. Shock proof, lets just say my design is much better than the stock that is molded plastic, and the front lense is glass.
i got you. i'm really not tryin to shoot holes in your presentation here. i'm very interested in fact. but i dont wanna spend alot of money then have it mess up. i know i've had water get into my stock lights and they still work. if water was to get into your light, would it make it blow the bulb or anything. if it does have that effect. is it just a simple bulb replacement?
Water will never get to the bulb, the only time it would is if you cracked the housing on the projector in which there is nothing I can do about that. If it gets into the lense then it will simply drain out of the hole on the bottom. Now if the bulb burns out on the halogen its 30 bucks for 2 new replacement bulbs and 100 for hids and they are replaceable unlike the factory lights, now if you are an extreme off roader then I would reccommend the halogen set up just because if you soak the ballast for the hid in water you could have a very terrible out come. Dont worrie about the questions, its good that you are asking them.
Yes and No. It took me around 15 hours to design the adjust assembly. These are not just lights. you get'
1. BRAND NEW CUSTOM MADE HEADLIGHTS WITH PROJECTORS RETROFITTED
2. WIRING ADAPTERS- SO YOU DONT HAVE TO CUT ANY WIRES
3. CUSTOM MADE AND LASER CUT ADJUSTER ASSEMBLYS
4. BULBS,SCREWS,BOLTS ETC.
Its a plug and play conversion that should take no more than a hour. And I have seen the factory headlamps and no offense they suck.