Spiderwebshade and freedom top panels - Jeep Wrangler Forum
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > General Jeep Discussions > General Jeep Discussion

Join Wrangler Forum Today


Reply
 
Thread Tools

Please support our sponsors and let them know you heard about them on WranglerForum.com
Old 04-29-2013, 03:12 PM   #1
Jeeper
 
Join Date: Feb 2013
Posts: 91
Spiderwebshade and freedom top panels

As I understand it the shade stays on??

I am trying to understand how I will be able to remove and reinstall the freedom panels with the spider shade in place?

Thanks

Boxerdad is offline   Quote Quick Reply
Old 04-29-2013, 03:14 PM   #2
Jeeper
 
SuperTJ's Avatar
 
Join Date: Mar 2013
Location: Waleska GA
Posts: 2,172
You just have to reach behind it. I had one on my 2010 . I removed the center bungee to latch the middle but that was it.

SuperTJ is offline   Quote Quick Reply
Old 04-29-2013, 05:07 PM   #3
Jeeper
 
Join Date: Feb 2013
Posts: 91
What about the two bungees where the center srew goes in to hold freedoms panels
Boxerdad is offline   Quote Quick Reply
Old 04-29-2013, 05:08 PM   #4
Jeeper
 
Join Date: Mar 2012
Location: Central Mass
Posts: 281
The only tricky part is getting the center latch covered by the shade. I just rub the latch through the shade; kinda sliding it open or closed. The two other covered latches you can reach up through the gap to open/close. Other than that it is easy peasy.
Seginus is offline   Quote Quick Reply
Old 04-29-2013, 05:13 PM   #5
Jeeper
 
Join Date: Mar 2012
Location: Central Mass
Posts: 281
Quote:
Originally Posted by Boxerdad View Post
What about the two bungees where the center srew goes in to hold freedoms panels
Not following you. The only spiderballs you need to manipulate are the front left and front right. You take them off to latch the panels. I don't put the two screws in anymore. They are somewhere in the garage.

EDIT: Just saw your other thread. I have the full shade so my comments may be off since you have the JKini.
Seginus is offline   Quote Quick Reply
Old 04-30-2013, 07:35 PM   #6
Jeeper
 
0II1II0's Avatar
 
Join Date: May 2012
Location: SA, TX
Posts: 542
I take off all 7 of the front spider balls. (three short that connect to the footman's loops and the 4 long on the sides) I let it hang down, put on the freedom tops, then use two long ones and connect to the freedom top latches. It's not tight but it's out of the way enough that it doesn't obstruct my view using the rear view.
__________________
"It's good to be back in a Jeep!" Me, 5/28/12
'We are either alone in the universe or we are not. Both ideas are equally terrifying.' Arthur C. Clarke
Medusa - 2012 Wrangler Unlimited Sport
Demi - 2002 Wrangler X
0II1II0 is offline   Quote Quick Reply
Old 04-30-2013, 07:49 PM   #7
Jeeper
 
Join Date: Feb 2013
Posts: 91
Well I'm 6'3" tall and with it in place with freedom panels it is to low so....

I took panels off took all the balls except the back two rolled it up and the used mini bungies to hold rolled cover

It will be easy to reinstall next time panels are off

Bed part it does bother my head and my hot head liner is visible which I like!!

Boxerdad is offline   Quote Quick Reply
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
If you do not want to register, fill this field only and the name will be used as user name for your post.
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off




» Featured Product

All times are GMT -5. The time now is 01:58 PM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC