Jeep Wrangler Forum banner

What I did to my Jeep today

1M views 16K replies 2K participants last post by  Dmsr63 
#1 ·
Let's see what everyone is doing to support the aftermarket Jeep companies of the world. Post up anything you've bought or installed on your Jeep today (ongoing...).

If you've installed it this would be a good place to post up a pic too.

Let's see how long we can keep this thread going. :D


I'll start: Viking Fastback Soft Top = Ordered
 
#4 ·
Holy Smokes Andy you are going to use .500 wall for your lowers? Those gotta weigh about what RK arms do. :D I didn't know that there were rocks big enough in KS to need those? :D Are you using a weld in bung or are the arms going to be tapped? And what size johnny joints are you using?
 
#13 ·
Kenneth has a full list of products he can make.

Many materials in Stock:
- 2" x .500 wall DOM
- 1.75" x .250" wall DOM
- 1.75" x .375" wall DOM
- 1.5" x .250" wall DOM
- 1.5" x .188" wall DOM
- 1.5" Dia. Chromoly Solid Bar for extra stout tie rods & drag links
- 1.75" Dia. 7075 Aluminum Solid Bar for a strong yet lightweight Control Arm


They aren't just bolt on items. They are for the DIY fab worker. Clayton is a very nice product and very expensive. But they don't make a 4 link setup with triangulated uppers :)
 
#23 ·
Changed the T-stat, topped off the radiator, removed the stupid a$$ flare extension in prep for my rocker guards. Oh, and I took a full size shovel and mounted it on my tire carrier.
 
#31 ·
Last night I installed the compressor for my Rancho 9000 "in-cab" shock controller unit. Tonight I'm going to install the controller piece and run the air lines. Tomorrow night, I'm going to hook the whole thing up to the shocks. I'll do a write-up and review when it's all done.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top