Jeep Wrangler Forum banner

Any experiences with the Synergy 1 inch coil spring lift?

2K views 3 replies 3 participants last post by  rubitron2015 
#1 ·
From what I have read,the 1 inch lift synergy progressive coil spring lift actually will give closer to a 2 inches without the heavy bumper and winch. Any experience with this coil spring lift on or off road? If so, how much lift did you gain.

Thanks
 
#2 ·
http://www.synergymfg.com/Synergy-Jeep-JK-TJ-LJ-XJ-Front-Lift-Coil-Springs-p-16404.html

Not sure about those springs. Synergy states their springs are designed to provide advertised lift with heavier aftermarket bumpers.

I am running their 3" springs on my JKUR. Stock bumpers, aluminum skids. 3/4" front spacers to off set wire rope winch. I think I got about 4" out of them when first installed.

I recall their info being fairly true to my results. Haven't bothered to re measure since.
 
#3 ·
I have Synergy 1" coils on front and back. I have AEV front and rear bumpers, M8000 Synthetic on the front. I have a 34" Load range E Toyo on the carrier. But I have removed the 1950's canister vacuum looking muffler from the rear. So I would say it is chubby but not heavy... I get a measured 2" front and back.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top