Jeep Wrangler Forum banner

Anyone running a rancho 3 inch?

739 views 3 replies 4 participants last post by  kjeeper10 
#1 ·
I'm looking a a rancho 3 inch kit with upper control arms and am wondering if anyone else is running it and what they think?
 
#2 ·
I am. Got closer to 4 inch lift. 9000 shocks. Rides nice. Pay attention to pinion angle. You won't have as much caster if you keep the pinion/driveshaft angle less than 1. Was a little skittish but played with the pinion angle and it's ok now. Still less than
You'll need a way to address the front driveshaft clearance issue. I went with a new Tom Woods.
 
#3 ·
I put it on last may when they had the sale. It is more like 4 inches. I just put on front lcas to fix my caster wish I would have done it when I installed the kit. Over all its not a bad kit. I had some issue s with the front trackbar and they sent me a new one free of charge. Not a huge fan of the trackbar even after they sent me one that was the right size.
 
#4 ·
Nice setup. You could ax the front uppers and add their drop brackets if need be. Uppers are used for caster angle but most run lowers for ease of adjustment. If the arms adjust shorter then stock .. You could actually run both or save up for lowers later on.

Rear uppers are nice for the rear in giving you pinion adjustment.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top