Jeep Wrangler Forum banner

More bump stop, right?

1K views 22 replies 6 participants last post by  ETOIMOS 
#1 ·
I think I might need some more bump stop.











 
See less See more
6
#6 ·
Not exactly sure how they are measured, but the yellow rubber part is 2" and the metal cup bracket part welded to the frame adds another 1".

Unless that is a hard rub, I'd run with it. That's pretty tight right there. At the most, I might add 1/2" to the top of those stops...
What do you mean by a hard rub? And to add .5" - 1", would I just replace the yellow rubber things with longer ones?
 
#5 ·
Unless that is a hard rub, I'd run with it. That's pretty tight right there. At the most, I might add 1/2" to the top of those stops...

The front is more difficult, because steering angle can have a big effect on what rubs and how hard, etc.
 
#8 ·
Rear..

The upper metal cup thing is 1", the yellow rubber thing is 2" and the square metal thing on top of the axle is 2". I need to make that square part 2.5"-3"?

Front...



The rubber cone inside the spring is 3.5".
 
#11 ·
I would add 1" because when you come down hard you will wish you had them
 
#12 ·
I can tell you the tf rear 2.7 5" bump would be about perfect.
 
#18 ·
Could be the angle of the photo but rear sb links look short.
 
#19 ·
#22 ·
Just put your sway bar at about -3* and measure eye to eye and that is what you need
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top