Jeep Wrangler Forum banner

Squeak after Teraflex Leveling Kit Install

2K views 1 reply 2 participants last post by  CzerOne 
#1 ·
I installed front 1" pucks from the Teraflex Leveling Kit about 2-3 months ago and lately have noticed a squeaking that seems to be coming from the front driver's side when going over bumps. I also installed the sway bar links (not sure if I needed to so I asked Teraflex afterward and they said if the sway bar ends are closer to level with the stock, then use those, but theirs probably wouldn't hurt anything). I will probably eventually add the other pucks up front and the rear spacer so I left the sway bar links on.

I haven't done any sort of real investigating to determine the source of the squeak but I'm guessing it could be the sway bar links. I have no experience greasing anything via a zerk fitting or what kind of grease I should use.

Any advice? Any other possible sources of the squeak?

I may just switch back to the stock and see if that fixes the squeak but greasing seems like an easier first option.
 
#2 ·
Get under the jeep with a pry bar or similar tool and pry on each new component listening for the squeak. Or get a friend to jounce the jeep while you listen for the source of the sound. I grease every component every time I do oil changes; if you do them yourself, pick up a grease gun at a parts store and a tube of grease to go with it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top