I am unsure what switch to ground/switch to power combination to order. So here is what I plan to do:
1. PIAA 520 Ion Yellow front fog lights that will be activated with a 3-way switch. The auto-on position of the switch will make the PIAA’s come on with the high-beams, and the other will be a manual on to a constant source (not tied to ignition). I believe I will need 2 relay spots for this.
2. Black Box Logistics DX series LED lights in the rear that will also be activated with a 3-way switch. Auto-on will come on with the reverse lights, manual on will be to a constant source (also not tied to the ignition) Again, I think I will need 2 relays for this.
3. The last relay will be unused for now, unless I can order the block with a sixth relay, in which I would then build a custom headlight harness to stop my lights from flashing.
All of this would be controlled by OTRATTW switches in a Daystar A-Pillar switch Panel. The writing on the switches would also be tied into the dome lights (with a diode), so whenever i open the door, the switches light up. Should be an interesting couple hours of wiring if i can get the above sorted out, and i would still save some money over going with a SPOD.