1999 Wrangler Transmission Question. - Jeep Wrangler Forum
Jeep Wrangler Forum

Go Back   Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ Tech Forum

Join Wrangler Forum Today


Reply
 
Thread Tools

Please support our sponsors and let them know you heard about them on WranglerForum.com
Old 08-31-2008, 12:34 AM   #1
Newb
 
Join Date: Jul 2008
Posts: 14
1999 Wrangler Transmission Question.

Hello, I have a 1999 Jeep Wrangler with a Manual Transmission. I need to know the procedure for changing the fluid. How much does it hold and what type of fluid should I use. Should I use ATF or 90 Weight?

Thanks.

cyberunlimited is offline   Quote Quick Reply
Old 08-31-2008, 09:07 AM   #2
Jeeper
 
richp's Avatar
 
Join Date: Mar 2007
Location: Pocono mountains
Posts: 1,559
I would us Redline MT-90, as for draining and refilling, there are two big 1" 'bolts' on the drivers side if I remember right, they are up high. Tip, remove the FILL or top plug first BEFORE you drain it, then remove the drain plug.
You are also going to need either a small hand pump that screws into the bottle to fill it or one of the suction/fill guns, they look kinda like a grease gun.
If you did not listen and can't remove the fill plug after draining you can remove the shifter and fill it from the top, PIA but do able.
You will need 4 quarts if I remember right, I normally buy it by the case and use as needed which is why I don't know off hand.
The transfer case is what takes ATF, for that I use Mobil-1 ATF.

richp is offline   Quote Quick Reply
Old 09-03-2008, 11:52 AM   #3
Jeeper
 
jtraider's Avatar
 
Join Date: Feb 2008
Location: skiatook(yes, the sticks), ok
Posts: 165
i had a question about this last week and got some really good advice. however, when i went to take the filler plug out, oil started pouring out. i hadn't removed the drain plug yet. is this normal? and if its coming out, does this mean that its too full or is there some pressure inside? also called the dealer to inquire about the mopar part number for the oil, and they said it was replaced with standard 10w30 motor oil. sorry, didn't mean to steal your thread.
jtraider is offline   Quote Quick Reply
Old 09-03-2008, 11:58 AM   #4
Knows a couple things...

WF Supporting Member
 
Jerry Bransford's Avatar
 
Join Date: Nov 2005
Location: Escondido, Calif.
Posts: 33,231
Images: 2
Quote:
Originally Posted by cyberunlimited View Post
Hello, I have a 1999 Jeep Wrangler with a Manual Transmission. I need to know the procedure for changing the fluid. How much does it hold and what type of fluid should I use. Should I use ATF or 90 Weight?

Thanks.
The FSM specifies a 75W-90 with a GL-3 or GL-4 being fine for your '99 manual transmission. Do not use a GL-5 75W-90 which is all you'll likely find on the store shelves. As Richp recommended above, Redline MT-90 is a very good choice for your particular transmission.

Jtraider, 10W-30 motor oil is roughtly the same viscosity as 75W-90 gear lube so that works too, probably not quite as well as Redline MT-90 though. And if you removed the actual fill plug and not some other bolt, no, the gear lube should not pour out of the hole. What transmission do you have?
__________________
When you have a choice, buy American.

Jerry Bransford is offline   Quote Quick Reply
Old 09-03-2008, 12:02 PM   #5
Jeeper
 
richp's Avatar
 
Join Date: Mar 2007
Location: Pocono mountains
Posts: 1,559
Yea, make sure it was in fact the fill plug and not the drain plug. How this could happen though is the last person to change it filled it thru the shifter hole, you can do that by pulling the shifter and pouring in which case I would measure it, with the filling thru the filler plug you fill till it runs out just like the transfer case.
richp is offline   Quote Quick Reply
Old 09-03-2008, 12:26 PM   #6
Jeeper
 
jtraider's Avatar
 
Join Date: Feb 2008
Location: skiatook(yes, the sticks), ok
Posts: 165
The plug was on the driver's side and had a torx head on it. i believe i have the ax-5? also, my drain appeared to be dead center on the bottom towards the front of the transmission and has an 15/16 head. i didn't see any other bolts on the sides that even looked logical to be a filler hole. i had noticed that it look like i had a leak and when i looked at this torx bolt i could actually turn it with my fingers. i went ahead and bought a full synthetic 10w30 to put in but i wanted to check some things with you guys first.
jtraider is offline   Quote Quick Reply
Old 09-03-2008, 12:28 PM   #7
Knows a couple things...

WF Supporting Member
 
Jerry Bransford's Avatar
 
Join Date: Nov 2005
Location: Escondido, Calif.
Posts: 33,231
Images: 2
With the drain plug on the bottom, it definitely sounds like it's the AX-5 which is what you'd have if you have the 2.5L engine.
__________________
When you have a choice, buy American.

Jerry Bransford is offline   Quote Quick Reply
Old 09-03-2008, 12:34 PM   #8
Jeeper
 
jtraider's Avatar
 
Join Date: Feb 2008
Location: skiatook(yes, the sticks), ok
Posts: 165
do i have the correct fill hole?
jtraider is offline   Quote Quick Reply
Old 09-03-2008, 12:35 PM   #9
Knows a couple things...

WF Supporting Member
 
Jerry Bransford's Avatar
 
Join Date: Nov 2005
Location: Escondido, Calif.
Posts: 33,231
Images: 2
Quote:
Originally Posted by jtraider View Post
do i have the correct fill hole?
I don't have an AX-5, mine is the AX-15 which is a little different, but it sounds like you do. Was your Jeep level when you pulled the fill plug?

Edit: Found this photo of where the AX-5 tranny's fill hole is on Stu's website... Jeep TJ Web Site of Stu Olson - N7QJP
__________________
When you have a choice, buy American.

Jerry Bransford is offline   Quote Quick Reply
Old 09-03-2008, 02:58 PM   #10
Jeeper
 
Join Date: Mar 2008
Posts: 97
Fill plug in a size 15 torx. Its on the driver side of the tranny. Drain plug is a large flattish bolt on the bottom more towards the back of the tranny.

Definitely recommend MT-90 over an engine or AT oil.
__________________
HEY CHRYSLER!

Rotting piece of junk with some bling in the rear axle.
sailsurf7713 is offline   Quote Quick Reply
Old 09-03-2008, 03:31 PM   #11
Jeeper
 
jtraider's Avatar
 
Join Date: Feb 2008
Location: skiatook(yes, the sticks), ok
Posts: 165
Is that the one that says 'don't remove'?

jtraider is offline   Quote Quick Reply
Reply

Quick Reply
Message:
Options

Register Now

In order to be able to post messages on the Jeep Wrangler Forum forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.



Thread Tools

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Shifting Into Four Wheel Drive And Transmission Question Allagash TJ General Discussion Forum 29 11-05-2014 12:59 AM
2008 Wrangler X 4 X 4 question Kroe JK Tech Forum 1 07-21-2008 12:33 AM
JEEP Wrangler 1999 Sport 4x4 4.0L 4 Sale sadeacs Classifieds Archive 1 05-02-2007 10:37 PM
'04 Unlimited Automatic Transmission Question hmenker TJ Tech Forum 6 06-14-2006 08:58 AM



Download our Mobile App

» Network Links
»Jeep Parts
» Featured Product

All times are GMT -5. The time now is 10:14 AM.



Jeep®, Wrangler, Liberty, Wagoneer, Cherokee, and Grand Cherokee are copyrighted and trademarked to Chrysler Motors LLC.
Wranglerforum.com is not in any way associated with the Chrysler Motors LLC