Originally Posted by Phinz
Thanks for the quick reply Ed. I'm about "average" when it comes to being mechanically inclined. Can you explain "If you clean the terminals on the switch" a bit more
The switch your turning to select the setting. Pull the center dash off and clean the terminal and connector to the switch.
Pulling the dash.....
Remove the defrost vent cover (big long piece on top of dash with defrost vent in it) by using a flat object such as a screw driver to pry up the side of it. Note!!! do this on the far end not the middle!!!
There will be 2 phillips screws at the top of the center bezel...remove them.
Open the glove box...
Grab the lower right corner of the center bezel....pull...it will pop right off.
There will be 4 screws holding the climate control box to the dash...remove the screws and pull it out.
Unplug the connector and clean it...di-electric grease is good to use after cleaned.
Put back in reverse order.