its been a long time coming but im finally going to install the suspension and adj. trackbars to my jeep this weekend. they are part of the dpg offroad ultiment kit. iv had the body lift and jks discos installed for some time now. i have questions tho about bumptops.
the bump stops were not on my vehicle when i bought it. so i went to the stealership and got some. surprisingly free, and surprisly used. whats a good way to clean them before i install them, without risk of dry rotting?
do i need hardware to install bumpstops or do they just plug in? i just have the rubber cone things(donkey D!@%$ as people in my jeep club call em), thats it.
in the pictures below i shoved a bumpstop and bumpstop+extension close to where they should be to check it out. i defintly dont need the extensions correct?
i measured from the top of my wheel to the inside of my fender and it was 7 1/4 inches. the bumpstop without the extension will be just a hair short...should i put a hockey puck in there or anything? i dont want to smash my fenders when im disconected.
lots of questions. hopefully lots of answers.
thanks
the bump stops were not on my vehicle when i bought it. so i went to the stealership and got some. surprisingly free, and surprisly used. whats a good way to clean them before i install them, without risk of dry rotting?
do i need hardware to install bumpstops or do they just plug in? i just have the rubber cone things(donkey D!@%$ as people in my jeep club call em), thats it.
in the pictures below i shoved a bumpstop and bumpstop+extension close to where they should be to check it out. i defintly dont need the extensions correct?
i measured from the top of my wheel to the inside of my fender and it was 7 1/4 inches. the bumpstop without the extension will be just a hair short...should i put a hockey puck in there or anything? i dont want to smash my fenders when im disconected.
lots of questions. hopefully lots of answers.
thanks