Jeep Wrangler Forum banner

cargo area measurements?

41K views 9 replies 5 participants last post by  boostlesstj 
#1 ·
i'm looking to make a "custom" cargo area holder, i was curious if anyone had the measurements on the cargo area?

i'm specifically looking from the "dropoff" from right in front of the rear seat to the rear where door shuts, from the top of the wheel well to the flat where the hard top would bolt to, from the floor to the flat of where the hardtop would bolt to, width between the wheel wells and width at the tops where the top would bolt to.

when i say top i mean as in where the sheet metal fold down to where it is actually in the interior. I would measure myself but i have lost my driving priveledges and the first sergeant has my car at the hangar so he can see it every day...
 
#3 ·
long story...

ended up getting pulled over for DUI/DWI and got an open container ticket and not a DUI/DWI, and being in the military you have civilian punishment and military(UCMJ)
 
#4 ·
i'm specifically looking from the "dropoff" from right in front of the rear seat to the rear where door shuts, from the top of the wheel well to the flat where the hard top would bolt to, from the floor to the flat of where the hardtop would bolt to, width between the wheel wells and width at the tops where the top would bolt to.
These measurements are not 100% perfect as well my tub isn't perfect anymore.

front to back on the floor: 36.5
from flat of wheel well to top of tub: 4
from floor to flat of wheel well: 12.5
Side to side from lip to lip: 56
From inside wheel well to inside wheel well: 36
 
#5 ·
Thank you, I got my driving priveledges back today out of the blue so I'll have to double check those when its not raining
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top