Took the Jeep for a test drive after clutch install... feels awesome, 60% of the previous pedal effort, no noise from release bearing... ahhh
But 10 minutes into the drive I get a Check Engine
light... I think ought-oh, left a sensor off? No... I drive home, scan the OBD (2.5L, 1998 SE, AX5) and get:
P0123 TPS Switch High Circuit
(it was iding high after Engine Light on way home)
P2300 Ignition coil Primary Control Circuit Low
I cannot connect the dots from clutch install to these codes... anyone?
I cleared them, but it is midnight here, and I am old
May drive one more time.