ECGS E-brake cable routing
I've installed my East Coast Gear Supply 8.8 and got my Jeep running but I can't figure out how to run these e-brake cables properly. I suppose its possible I just need to adjust it further but when I tighten the nut on the tensioner is becomes clear that one side is tighter than the other... Any chance someone has a picture they could show me that would help make sure I have these cables routed properly with the correct brackets on each side?
Any other way to adjust the e-brake besides tightening the tensioner under the vehicle?
The e-brakes are not grabbing at all right now.
2001 Jeep Wrangler Sport 4.0L Auto - DPG Ultimate Kit, ECGS 8.8 4.10, 33x12.5 Duratracs on 15x8 Ultra Type 164