Noob question, I got under my 2000 sport 4.0 5-speed (51000 miles) to check things out and see if everything was tight. The only thing I found not tight was my front drive shaft. It has about 1/4" play in both the shaft and yolk. U-joints look good and tight. I tried in 2H, 4H, and 4L......nothing changed. 1/4" play in all settings. Is this normal?......or do I have something going wrong.
00 - 4.0 - Sport - noobie
When nobody knows what color your Wrangler is, you know you've had a good day.
So when you grab hold of the shaft and give it a shake you have play in it? Can you tell if it's coming from the ujoint or the pinion? Ujoints are cheap and easy to replace. Might just be a good idea to do it anyway.
Also as a wise Hackle once told me over and over and over again. "It looked tight" is not the right answer.
President - Arizona Off-Highway Vehicle Coalition
Vice-President - ASA4WDC
Arizona Rock Rats
On the front drive shaft, there is a knuckle like mechanism when it comes out of the transfer case. there are u joints also in there. If everything is tight in there and tight on u joint on ur front diff, then the driveshaft should not have any play. it did the same thing to mine. Just drop the skid and give the driveshaft a shake and see if any is loose.
boosted inline 6 50. trim turbo
40" super swamper boggers
high pinion d44 front trussed
ford 8.8 rear axle conversion
se 9500 milemarker winch
locked front and rear
rough country steering stabilizers
clayton long arm
3inch body lift
2 coil spacer lift
eagle alloys 15's
on-board air system
kc daylighters 100w long range