Looking to get my hardtop sealed up properly. Looks and sounds as if a lot of mine is missing from the previous owner... Driving I can barely hear the radio over 60mph from all the wind blowing in.
Bought this Original Replacement Parts D4012 - Hardtop Seal Kit - Quadratec
and it seemed to help a little bit but not much. While installing it I realized that there was no original seal along the front edge where the hardtop meets the windshield (Instructions from that kit say there should be one there already). I did have some torn up seal along the side where the hardtop meets the tub and replaced those.
During my searching I discovered "mucket" seals which my Jeep is missing (small rubber molded pieces that go where the edge of the tub meets the door).
So my real question is what ALL would I need to seal this thing the way it came from the factory? As far as I can tell I have a rubber and relatively worn down seal along the edge of the windshield attached to the windshield assembly, rubber seals along the edges of the full doors, the seals I just installed along the sides of the hardtop and the front of the hardtop where it meets the glass. There are no seals on my hardtop to meet the door frames and no seals on my actual tub at all - should there be? Also no seal on the tailgate (I've heard of a bar that needs to go there) but I just have bare tub for my tailgate aside from the little rubber flap attached to the glass.
I can pull the top and take a bunch of pictures tomorrow, I'm sure that would probably help but I'm trying to get an idea what I need to start looking to purchase.