Jeep Wrangler Forum banner

More Body Lift Woes

2K views 28 replies 9 participants last post by  DiPietro 
#1 ·
If punching a hole in my radiator last week wasn't enough, apparently in my haste I forgot to tighten one of the side body mounts for my 1" PA lift.
I found the bolt and rubber bushing down the road, but NO body puck.. :zap:

So now I'm missing one of the larger side mount pucks.. Where in the heck can I just get one puck. I say that because I know I could makeshift any 1" spacer.. BUT I want the Larger-Round-3" Black puck, so it matches...
(not to be anal)
I have an email into 4WD already, but wanted to run it by you guys..

Any Help?? Ideas??
 
#28 ·
Maybe I can find something 3" in Diameter and 1" tall and just drill a hole through it..
From Wikipedia, the free encyclopedia
In ice hockey
Ice hockey requires a hard disk of vulcanized rubber. A standard ice hockey puck is black, 1 inch thick (25.4 mm), 3 inches in diameter (76.2 mm), and weighs between 5.5 and 6 ounces (156-170 g)
worth a shot ya think?
:cool:
 
#24 · (Edited)
Any one have a spare 2 or 3" PA kit there not using.. I could slice off an inch or two???

Maybe I can find something 3" in Diameter and 1" tall and just drill a hole through it..

From Wikipedia, the free encyclopedia
In ice hockey
Ice hockey requires a hard disk of vulcanized rubber. A standard ice hockey puck is black, 1 inch thick (25.4 mm), 3 inches in diameter (76.2 mm), and weighs between 5.5 and 6 ounces (156-170 g)


worth a shot ya think?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top