Originally Posted by trebormesos
front ones are ok as is. it's the ones on the sides i'll to replace.
Hoping to not have to do a big mod for them
Just go to Radio Shack and get these parts:
4 Rectifier Diodes #IN4004
2 560 Ohm ˝ watt Resistors #271-1116
3 Colors 18 gauge wire
then solder them up like the picture below and ground the negative wire of the led and you should be good to go. Just be sure and insulate the bare wires then place the whole thing in a piece of tubing or something else semi rigid.
This will allow the led to be the marker light plus blink when your turn signal is on