Jeep Wrangler Forum banner

skid plate help

610 views 2 replies 3 participants last post by  Shoe 
#1 ·
I did a transmission fluid and filter change, when I put the skidplate back on, the front mount on the right the threads only went in a little bit and then just spins! is there a nut inside the frame that came loose? So now it is a couple of threads in and I cant get it on or off. and it rattles against the frame. any solutions ...I hope
 
#3 ·
It's called a "nutsert" If you do a search you will find a lot of info about them. You might be able to tighten it down enough to hold tight again. If not it will have to be replaced. Just be glad you got the skid off before it started spinning!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top