Jeep Wrangler Forum banner

2002 F250 Super Duty Axles- anybody swapped these?

944 views 3 replies 2 participants last post by  YJ fanatic 
#1 ·
I have a good lead on a very clean, low mileage pair of axles.
4.10 gears, OEM LSD out back, high pinion front driver side, disc brakes, etc.
I have a spare set of wheels that would also fit these axles.

Anybody swapped these before?
I am assuming the axle width would be about 6-8" wider than the YJ.
Not super concerned about that.
But I think they would be perfect with a set of 35's and the long block 351W Ive had in my garage for about 8 yrs.
 
#2 ·
That'd be a Dana 50 front most likely, and a Sterling 10.5 rear. They'll definitely hold up to the power you're looking at. I believe they're 69" wide, so 9-10" wider than the stock axles. You'll also have to outboard the springs up front because the perches are wider than the stock axles. Luckily, people make kits for that. They wouldn't be a bad choice for axles, just not as many options for parts as other axles like D60s, 44s, or 14 bolts.
 
#3 ·
Its def a Sterling 10.5. Nearly identical to the one in my truck, 05 F250 PS.

I am 99% sure its a D50. Unless the guy doesnt know the F350 SRW could have had the D60. Pretty sure all the DRW F350 had a D60.
 
#4 ·
If you're lucky, that F250 could have a D60 up front. There weren't many, but I've seen them. Lots more parts available for them and a bit stronger.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top