Hello all. I'm a new member. I've used your forum for info before and am always impressed with the amount of knowledge presented. Here is my delimma. I have a 1994 wrangler, 2.5 four, with an ax-5. I drove it into the garage to replace said ax-5. Imagine my delight when it refused to start afterwards! I have since replaced the crank and cam sensors. Also the cap rotor plugs and wires. A new fuel pump (sock and external filter too) went in last weekend. I have good fuel pressure, and power up to the coil. I should add that first I verified everything was plugged in. I am wondering though, are any of the connections/ sensors on the tranny capable of keeping the engine from firing? They were on the unit when I installed it, so they seem to be the only factor that changed between it running and not..sorry for the long post, any help will be greatly appreciated!!