Have been poking around in here for a few days now, looking for threads on Axle Seal replacement and have not had any luck finding what I am looking for.
I have a 88 YJ with the D30 up front. I have re-geared to 4.56 and have installed an Aussie locker, however, am still running stock axle setup with the disconnect.
My passenger (Disconnect) side axle seal is leaking. Not bad, but enough to drip on the pavement a bit when parked for a day. I hate the drips, and rather fix something than let it go so I am trying to figure out how to change this.
I recently moved and can't find my Haynes which sucks, but I am sure I will run across it soon, but in the mean time any suggestions.
I was told I would have to pull the chunk out of the front end which I understand if it were the driver side, but what I have found suggests the seal is on the wheel side of the disconnect, therefore, could I just pull the wheel bearing, axle, and CAD housing and be able to get to and change that seal, or am I missing something?
Any help here is greatly appreciated.