Originally Posted by 95riogrande
going to replace the seal just outside of the vacuum motor housing looking to make the tool so I dont have to pull the carrier out. I know its 1/2 threaded rod but im unsure of the sizes of the washers to use. I realize they have to be small enough on one side to go into the tube and sit perfectly on the seal and large enough to go over the tube to draw the seal into place. has anyone made one recently or in the past and remember setup?
i dont recall the size off the top of my head, but when you get the seal, just size a washer up to it that is slightly smaller.
'90 YJ, ford 8.8, SOA, lincoln front, aussie rear, 4.88s, swampers.