Jeep Wrangler Forum banner

Carb Issues

871 views 9 replies 4 participants last post by  dhealy1676 
#1 ·
I recently replaced my stock carb with a weber 32/36 dgev carb that I got from webercarbsdirect.com. I am having issues with the carb. When I accelerate, it boggs down. When you chock the air coming into the throat of the carb its fine, so I thin I need to increase the accelerator pump jet size. The only place I can find them is through weber carbs but they don't have a .060mm jet and they are not sure if or when they will get more in. I've looked all; over the interweb and cannot find one. Does anyone have any ideas where I can get a .060mm single discharge accelerator pump jet for a weber 32/36 degv?
 
#4 ·
That is were it should be have you tried decreasing/increasing the psi to see it it helps?
 
#5 ·
well...I put it on the return side of the carb. I know I know, but that were I put it to get the pressure that high. On the supply side of the carb I could get the pressure above 1.5/2. It only does it when you accelerate hard, like pulling out into traffic. When ive got the air cleaner off and I cup my hand over the intake and dump the throttle it's fine.
 
#7 ·
Do you think advancing the timing might help?

I wonder if it is bogging because of too much fuel?

Good Luck, L.m.
 
#9 ·
So on the supply side with the regulator set at 4 you are only getting 1.5/2?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top