Jeep Wrangler Forum banner

Clutch shifting issue

520 views 2 replies 3 participants last post by  kik 
#1 ·
I noticed an issue shifting into 2nd gear (first is too low so don't really use it on the street) and reverse. The long story is I noticed this a year ago and replaced the master cylinder and it seemed to solve the issue.

However here I am again and experiencing the same problem. I thought maybe the master cylinder I got had gone bad, so I replaced it, an bled. And now I can't shift into any gear at all. While bleeding many iterations, I was able to roughly shift into 2nd or 1st (like before switching the master cylinder).

I am now suspicious of the master cylinder being the root cause. Other information:

  • had the trany rebuilt about 2K miles ago

  • problem gets worse the warmer the engine is, or the longer I drive it

  • 93, 4.0 have not replaced clutch or bearings or slave since I have owned it.

What do y'all suggest?
 
See less See more
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top