I'm replacing my pinion and carrier bearings in my dana 30 and have a few questions. The jeep is a 93 wrangler, 4.0, 5 spd. I have everything remove from the front end and as i'm cleaning the tubes out i see a female splined bushing (?) on the inside of the shift fork cutout. Is this a bearing that needs to be replaced?
Also there was not a passenger side axle seal. Where does this seal go?
Pass side seal is outboard of the CAD (shift fork cutout as u put it). I was wondering about that bushing as well. The replacement is only 15 bucks but I have no idea what the replacement process is. Hopefully someone else will chime in.