Dana 60 outer axle seal?
I was told Dana 60 axles dont have outer seals. However, after 4 months my inner seal on the front drivers side tube has gone out and was told its most likely due to sand and dirt getting into the tube from no outer axle seal. Is it possible to put an outer seal on a Dana 60? Or am i stuck replacing the seal after every 5 or 6 outings? The pass side and rear seals are holding up well. Both front and rear axles are Dynatrac ProRock 60s
95' YJ 4-Banger, 5" black diamond lift, Bilstein shocks, shackle reversal kit front and revolvers rear, 33 x 12.5 BFG A/Ts, Dynatrac D60 Axles front and rear, ARB air lockers front and rear, custom drive shafts, 3/4 ton break calipers, 10k LB Engo syth winch, 50" LED windshield light bar, black Monstaliner inside, Predator Green Monstaliner outside, marine speaker sound system, marine vinyl dash and seats. Many other little goodies!
Swap to a 4BT diesel in the future? Most likely.