Jeep Wrangler Forum banner

Headlight adjustment

4K views 6 replies 6 participants last post by  cookin out 
#1 ·
I have a 1990 yj headlights way off
This is my setup 1990- yj- 3 in body lift
2.5 suspension lift- 33s- anybody know how
Adjust or set any help is appreciated
Thanks
 

Attachments

See less See more
1
#2 ·
I have a 1990 yj headlights way off
This is my setup 1990- yj- 3 in body lift
2.5 suspension lift- 33s- anybody know how
Adjust or set any help is appreciated
Thanks
There should be adjustment screws under hood that are hex head just turn them to adjust beam shine headlights at large object like garage door the sealed beam will move in the whole socket, turn untill even. Hope this helps.
 
#4 ·
Maybe i stated this wrong i know where
adjusters are i meant from adj wall( garage door- fence-whatever)
How many feet back. How high. And doesn't the driver
Headlight point towards pass side a little
All info is appreciated
Thanks
 
#5 ·
When I adjusted mine, I took my other car and shone the headlights into the garage from outside the garage, made a note of where each beam was hitting, then put the Jeep in the same spot and did the adjustment that way. I'm not sure how correct that is, but I think it's good enough.
 
#6 ·
Park your jeep close to a blank wall, mark the centerline of both headlights with tape. (Make an L shape with masking tape.) Back straight up and park 25 feet from the wall. Start with low beams, adjust so the intensity is two inches below the horizontal line and two inches to the side of the vertical line. High beams on, the high intensity zone should be vertically centered with the exact center just below the horizontal line.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top