Jeep Wrangler Forum banner

Leak from Cat to Muffler after Install

798 views 5 replies 4 participants last post by  DREDnot 
#1 ·
Hi Everyone,

So I replaced my stock exhaust with a Banks cat back. It was a real pain in the ass because of the typical rust issues, and I had to cut off the old muffler to get it off. In doing so, I took about an inch of the cat with it...

Now after fighting to get the new exhaust system up there is air coming out of where the cat and the muffler meet, and condensation is dripping from that point as well. :atomic:

If anyone can give me some suggestions on how to fix this without taking the whole exhaust apart it will really make my week. Do they sell a tape or something that I can seal it with, or a flange? Any help would be much appreciated. Thanks!
 
#2 ·
Any quick fix is just crap.

Best thing would be to take it to a muffler shop and let them weld it.
Any adapter will restrict the flow and negate your spendy exhaust
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top