swapping pass side motor mount. old mount is gone.
the trans mounts in the center of the skid plate are loose. the motor is jacked up. I got the new mount loosely bolted to the motor. I began to lower the mount close to the proper height and the remaining two bolts are almost an inch off? also at this point the 4wd shifter is under neath the frame (the top half of that shifter is removed)
X2, I replaced my Driver side mount and only jacked the motor up and it didn't want to sit right. I bolted the mount to the frame and lowered the engine to it. This was the only way I could get the bolts to line up on the frame.
There has to be something keeping it from lowering, I would look up under the hood. Look to see if the left side of the engine is hitting anything, can you post random pics of the mounts so we can see for any ideas?