Jeep Wrangler Forum banner

need help

714 views 4 replies 3 participants last post by  peterbiltjunkie 
#1 ·
engine would idle smooth before nutter but would fall on its face at nything beyond 2000 rpms. i nuttered it and now i cant even get it to idle smoothly. starts hard and runs like sh#?! any ideas where i went wrong? thanks in advance
 
#4 ·
I put mine at about 3/16" set timing with vac. disconnected @ 10* BTDC then adjust the carb.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top