If anyone has done this before im wanting to know if i have done this right!
I had 3.07 gears in my rear end. so I bought 3.73 to match the front, I pulled off ring and pinion pressed on a new bearing, There were no shims in it before,
and I cant seem to see where you could shim pinion out, so I had to shim at carrier bearing moving it 1/16 of an inch to the right which made me remove the washer on pass side and place it on drivers side moving axels 1/16 of an inch, in on drivers side and out on passenger side. now my gears are set right but surly ive done somthing wrong! anyone with advice