Well all, my first tech question. I know ya'll are the best out there so...My question, I know the firing order on my 4.0 93 is 153624. But after I changed my plugs, wires, cap and rotor it just seems to start harder. I gapped the plugs correct and put every wire where it started (so I thought). Just wondering if anyone has a picture or something to go buy. The distributor isn't marked to tell where #1 is. So I guessed and think I'm off one way or the other? So any pictures or any thing is greatly appreciated.
I forgot to mention. When I start the jeep in the morning(first start) she fires right up. But after driving like 25 miles give or take. That is when she seems to take a few seconds to turn over. Like the heat slows the starting. Starter is only about a month old. Thanks again
If it is starting right up cold and is not mis-firing then it sounds like the wires are in the right order. If it is giving you problems after warming up then you may also want to have the ignition coil tested...
if it cranks slow when its warmed up the problem is your timing
Is the timing something I can check or do I have to take it somewhere? I have a timing light, so just do the norm and check it ? Or do I need to take it somewhere. I can do a 302 & 351 with my eyes closed. I have never messed with a little ol jeep motor. Thanks everyone.