07-17-2012, 05:00 PM
Join Date: Jul 2012
Location: Delta, PA
YJ Rear Bumper Bolt Pattern
(Mods: if this thread is supposed to be in the Fab thread instead of YJ, please move it)
I'm designing an aftermarket set of bumpers, both front and rear, for my YJ. I was able to find the front bumper bolt pattern on here, however I can't find the pattern for the rear bumper.
What I need is the measurements (center to center & hole diameter) for the bumperette holes, as well as how far between the driver and passenger groups. Also I need the measurements for vertical hole in the bottom of the frame right near the rear bumper. I'm planning on using 8 bolts on the rear bumper & crossmember, which I understand is weak, and then have my tow hook mounted upside down as well as steel reinforcement tabs going from the bumper to the frame, so I would need the measurement from the center of the frame hole to the face of the crossmember as well as the diameter (I think it's 7/16").
Diameter & Spacing of bumper crossmember (bumperette) holes
Diameter & Spacing of vertical frame holes
Before someone posts "why don't you take your bumper off and measure" I don't have the proper tools to do so at this time.
1995 - 2.5L Low Output Wrongler