Originally Posted by BamaMac
Checked VIN and all with the factory and they said it was a rubicon. Just there are no switches in the lower switch panel for the lockers or sway disconnect. I guess it is possible they could have been taken off! If so it should be relatively easy reinstalling a few switches! If that's all that was done by the previous owner
I don't know where your info. is coming from but the "factory" doesn't tell you that you have a "Rubicon". The build sheet will list what you have, which if you have what's listed below then you have what an 08 Rubicon has as standard equipment. A Rubicon at the minimum has this for an 08, plus it will have a sway bar disconnect. There is no place on the factory build sheet that indicates "Rubicon".
DHWS 4:1 Rock-Trac HD Part Time 4WD Sys
DJSS Next Gen. Dana 44 HD Front Axle
DMFS 4.10 Rear Axle Ratio
DRZS Next Gen. Dana 44 HD Rear Axle
DSES Tru-Lok Front & Rear Axles