Jeep Wrangler Forum banner

ACE Engineering New pro series rear bumper and tire carrier sneak peek

92K views 416 replies 115 participants last post by  kev324 
#1 ·
Just a quick peek at the new ACE rear bumper. This new bumper will be offered with and without the 6" LED light bar provisions on both sides. I will update with more information in a few weeks and answer any questions. This is just to show our new design. Cost, release date weight is not available yet. As soon as we finish the adjustable tire mount and a few other mountable options we will update everyone. Thanks for looking and I appreciate the feedback.

Thanks

Adam
ACE Engineering
 

Attachments

See less See more
3
#2 ·
Bad Ass I want one.

I wish ya'll made a mid length front pro bumper with bull bar.. Hint Hint.
 
#6 ·
I like the lines on this one alit more than the previous tire carrier. It was just too boxy, but this carrier is slick!
 
#7 ·
I see where this thread was started June, 2011. Is this pro series rear bumper available yet? It isn't on the website. I have Shrockworks front mid-with winch bumper and rear w/ tire carrier ordered, but they haven't been built yet. I'm in month 1 of a 3-4 month wait. I migh consider switching out the rear bumper for this ACE bumper.
 
#8 ·
This thread was started today...
 
#11 ·
How is the tire carrier held in place? It looks like the end is just hanging there without any kind of latch. Does it attach to the factory tire carrier somehow?
This is just a guess, but I'm assuming this one will latch the same as their other carrier, which uses a double heim joint that attaches to the tailgate so it has a one-handed operation and opens with the tailgate.
 
#15 ·
looks sharp, cant wait to check it out! are the rear slots an option, something that can be changed based on what type of lights you want? certainly a feature I like about the current bumper is how I was able to pop my factory fogs in no issue for some backup lights

man I wish I lived closer to you guys, I would hit you up for sure for some fab work!
 
#28 ·
Hard to tell from the pics, but is there a place for the 4 pin connector to mount?
this ^^

I'm loving my boxy ACE bumper and give it a 99.9. If it had a clean factory style mount for the connector it would be a 100.
 
#20 ·
Very nice! Love the lines. Definitely have my eye on this one. Don't forget to put a little tab on there so we can secure our factory 4 pin connector easily. Looking forward to seeing what kind of accessories can be mounted, maybe a rotopax or a hi-lift, or traditional jerry can. Good stuff!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top