Hi guys... today ill be installing new speakers in my jk... polk audio components in the front and 2 way coax in the sound bar... i also have a 4 channel 800w amp to power them
I put mine on the back of the rear seat, larger portion under the felt covering. I didn't want to have it under the seat if I wheel deep enough and get water inside the cabin. I'll try and get pictures later.
^
I put a RF 3ixty.3 there. It's 5"x9"x2"
Just picked up a piece of aluminum flat bar from HD, bent it to the right angle and drilled a hole in it. There is already a threaded bolt hole right in the center of the bracket that goes across the bottom there so I just used that. Ran a couple of zipties for safety. The knee plate even went back on
My amps, I placed under the front passenger seat.
I just used 2 pieces of 1/4" plywood stacked, glued together and cut so there was a lip for one of the bars going across to rest against. I used pipe straps to bolt one end of the board my amps sit on to the seat rail that goes across the seat and Velcro to hold it at the front.
Works perfect.
That's a JL xd600/6 and a JX500/1 stacked under the passenger seat along with 4AWG power wire, 12AWG and 16AWG speakerwire plus RCA cables
Ended up mounting to the gate... im curious as to where everyone else ran their power wire though... i dont like where mine is currently
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Ask a question
Ask a question
Jeep Wrangler Forum
9M posts
468K members
Since 2005
A forum community dedicated to Jeep Wrangler owners and enthusiasts. Come join the discussion about reviews, performance, trail riding, gear, suspension, tires, classifieds, troubleshooting, maintenance, for all JL, JT, JK, TJ, YJ, and CJ models!