Jeep Wrangler Forum banner

Fender cutting worth...

2K views 8 replies 7 participants last post by  lt721 
#1 ·
#6 ·
Like someone else said, use a jig saw then sand (I used a drywall rasp, then sand paper). Didn't take long at all.
 
#7 ·
Its super easy to do, as stated, just tape if off... I used a dremel tool to cut mine, broke a couple of disks but other than that... I also popped the fenders off before I started cutting. Had to go to the jeep dealership to replace the ones that I broke. That was the most expensive part of the process... I have heard of people doing it with jig saws, dremels, rotozips, and a heat gun and utility knife. You should definitely do it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top