Jeep Wrangler Forum banner

got the Rigid Fog cubes mounted....

822 views 3 replies 2 participants last post by  JeeperJake 
#1 ·
had a slight fog coming home around sun down...so far these bastiges got a lot of PROMISE!!!!

Will update in few days after more on-road experience.

Yet there IS a ton of light from 3" cubes....and it has sharply defined edges, will see how the heavier weather affects visibility.
 
#2 ·
Trial run tonight; about 15 miles winding county paved road, lots of curves & no fog line.

OK, no fog tonight either....but using the Rigid fog 3" cubes, I am beyond impressed!!!

VERY more-than-adequate for close-in ditch-to-ditch daylight seeming illumination. Best I've seen in fact, for a fog light.

Haven't dealt yet with oncoming traffic or actually heavy fog.

Sharp cut-off lines make this seem like excellent purpose-designed ~fog~ light. Excellent pairing with the 42W yellow bulbs in OEM fog cans with the upgraded D. Stern headlights.

Now I can see so good may have to just go drive around for a while back on the county twisties. No question of bumper-mount was proper location, and any critters moving suddenly across the asphalt at least now can be seen.
 
#3 ·
That's awesome.

Rigids are awesome. I got the driving lights and mounted them on my bumper.

I also got the spot lights and mounted them on the Pillar either side of the windshield
 
#4 ·
skk: that's got to be an overpowering display of lumens at your fingertips!!!

do you run some kind of SPOD/similar panel or mount separate switches hither & yon?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top