Originally Posted by OH9JK
JK License Plate Bracket & Hardware
- 4 Nuts (6036683AA)
- 1 Bracket (68064720AA)
- 4 Hex Screws (6507238AA)
- 1 Lamp (68003487AA)
I think you will have to move the wiring harness from the bumper location up to where the plastic knock out cover is (just below LH tail light). What I don't know is if the connector is of the same style as the US.
Well he has wires on the new bracket, so he'll just need to clip them and connect them to the new wiring.
Basically, you'll need to remove the wires from the bulb at it's present location, remove the license plate delete plate and pull the wires through that. The wires should be running down that area down to the bumper and to your current position. If not you'll need to run them to the corner and pass them up through the void inside the corner to the new location. If you remove the driver's side rear light, you'll have more room. Once you have the wiring to the new plate location, cut off the excess and connect them to the new wiring. The bracket itself is held in by three screws. They basically look loke wood screws, so finding replacements shouldn't be that hard.