Jeep Wrangler Forum banner

Need help: rear washer nozzle

9K views 3 replies 3 participants last post by  cptslewis 
#1 ·
Bought a used hard top. Plastic cover over wiper arm nut was missing. Didn't think it was a big deal. Today I realized the washer fluid nozzle is apparently made onto the shaft that nut goes on and its broken off too. #@$%&*!

Where can I find a rear washer nozzle? Does it screw on? Or is it a permanent part of the entire wiper motor assy.?
 
#4 ·
I just dealt w this. On my 2010 the washer fluid goes thru the shaft. I busted the plastic cover so now it shoots out 15 feet behind the jeep. When installed the water hits the cover and cascades down the wiper blade. All you should need is the plastic cover which I believe is #9 on the diagram. Cost at my dealer is 30 bucks.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top