Put some new bumpers and tire rack along with some Smittybilt rock guards. Only issue I have are where to find a new rubber seal for the rear tire wire. Is there some sort of after market cover for the old tire holder? I lost one of the fasteners for the grill to the engine. Other than that minor stuff it all went smooth about 5 hrs start to finish.
No lift, at some point maybe. I believe they are 265/75/16. The steps where just a hair short and one of the welds w bit too thick so I had to grind and beat em in with a rubber mallet, nothing to hard though.
nah they don't rub. they are snug tough maybe inch or so from body. Had to be careful putting them on so I didn't bang the body till I got them in position. The body curves in a bit just below the door so they look closer than they are.