Jeep Wrangler Forum banner

Rugged Ridge light bar installed (pics)

2K views 5 replies 4 participants last post by  redneckdan 
#1 ·
Finally got my Rugged Ridge light bar installed over the weekend and thought I'd post up a few pics for anyone considering it. I wanted to do something different. It uses three 13.5" LED bars instead of the traditional single 50". The lights also mount just below the roof line which I believe should make for less wind noise.

Overall I'm really happy with it. Installation is very easy - just remove the factory A pillar corner pieces (6 hex bolts each) and replace them with the rugged ridge bar. The pillar mounts also have a foam backing to prevent scratches or rattling. It came very well packaged with a nice think powder coat. The finish actually matches my Smittybilt gen2 bumper and side armor perfectly.
 

Attachments

See less See more
4
#2 ·
Good looking Rig!
 
#3 ·
Hey I saw this pic on the 4 Low Jeep page! Looks great!
 
#6 ·
I am pretty happy with mine. You may notice a bit of a 'flicker' when off pavement. The mount arms do flex a fair bit and that movment causes the light pattern to move.

I wish RR had a roof rack that worked with the light bar. I probably will build my own this spring. Trying to decide between tub mounts or frame mounts in the back.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top