Jeep Wrangler Forum banner

soft top foam

4K views 9 replies 9 participants last post by  gillamonstar 
#1 ·
On my factory soft top there is some foam on the front corners. Mine seem to be peeling off when the roof is back.

Is it necessary that those pieces are there? Or are there any other fixes that anyone has come up with.

Thanks.
 
#2 ·
My 2014's foam was worn out pretty quickly (I put the top down almost daily in the spring and fall, and leave it down most of the summer). I tried removing the foam for a while.

Wind noise was much louder with it removed (top up/windows up). I also got a few water drops from that spot while at a DIY wand carwash.

I went to Home Depot and got some foam tape and put that on. Much better. The Home depot stuff isn't as nice as the factory stuff though. The factory stuff is a little more rubbery and springs back better.
 
#8 ·
On the picture shown on that link, where do the two long (thinner of the two types) strips go?

I found those peices stuck to the outside of my top. Not sure how they got there and where they should be.

Thanks.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top