Jeep Wrangler Forum banner

Trek armor and rear seat belt

1K views 5 replies 6 participants last post by  Jetwag03 
#1 ·
Has anyone had binding issues on the rear center seat belt?
I am trying to figure out if the seat covers are causing a problem or if the seat belt itself is not functioning properly.

Thanks

Ben
 
#4 ·
Just put my covers on and my center rear seatbelt is tight as well. Unbolted the belt a court le of times making enough slack to get the seat locked upright, but unable to get the seatbelt moving in case a 5th passenger needs it, any Ideas?
 
#6 ·
FWIW, I had a similar issue also, but in my case it was because I dId not do the install correctly. The center seat belt needs to be on the outside of the seat cover from top to bottom, This can only be achieved by removing the center seatbelt bolt and slipping the belt over the outside of the seat cover. This might not be the same issue you are having, but I figured it can't hurt to share what fixed mine.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top